NorskWall 17 sq.ft. Installation Instructions

Tools Required: Drill Stud Finder Pencil Step stool / ladder Level Tape measure Rubber mallet

	Mark the desired height of the NorskWall on your wall.
	Draw a level line at this point (start at stud) to the end of where you want the NorskWall to stop.
	Mark with a pencil your stud locations on this level line.
	Place Top Rail just above the line (so you can see the stud marks). Make sure it is level and install screws starting them into indented slots at each stud location.
	Continue adding more Top Rail across desired line until Top Rail of Track is complete. Make sure you use a Dowel and Retaining Ring in the middle of each Dowel to connect each Top Rail together. (If possible, try to use 1/2 of one stud for each piece of Top Rail.) Lightly tap the end of the Top Rail with a mallet to seat the Top Rail on the Dowel.
	Now that your Top Rail is complete and level, use a level and draw a line straight down each stud mark to just below the bottom of the last panel that you will use for your NorskWall. Now take each NorskWall Panel and slide into the Top Rail, which will cover the screws from the previous steps.
	Install screws in the bottom Panel where indents are located and where you have marked the studs.
	If you are only creating a single column NorskWall, skip to step 10.
	If you are creating a NorskWall with multiple columns, add Dowels in each hole with Retaining Rings in the moddle of each prior to connecting the next Panel and repeat Step 6 until all Panels are installed.
	Install Bottom Rail pieces by simply placing them in the bottom Panel (where screws are installed) and firmly pushing and locking them in.
	LAST Step: Use a long piece of Side Trim and cut to size (hack saw or other appropriate saw for cutting PVC). Install Side Trim Clips (1 clip per track) by sliding Clip(s) onto rail located in Side Trim and snap into side of Track.

Please read before installing or risk damaging your NorskWall

	If there is a gap between two Top Rails end to end or Bottom Rails end to end because of the Dowel/E-Clip, you can counter sink the hole 1/8" with a 3/8" drill bit. Also, it you are having trouble getting the Dowels in any of the Dowel holes, you can bore out any of the Dowel holes with a 7/32" drill bit.
	If Side Rails don't fit because the Panel, Top Rail, or Bottom Rail are too long, use a saw to cut off extra length.
	If you are having trouble getting Dowels into Dowel holes by hand, you can tap Dowels lightly with a hammer or mallet. Click here for installation instruction videos.

Print This Page